Course over and above the fourth course shingle.
Shingles roof installation instruction.
Install a full shingle against the right edge of each shingle in courses one through five.
Do not install glenwood.
Legend installation instructions 36 spanish 426 96kb pdf legend 36 quick start guide 857 73kb pdf pinnacle pristine installation hp42 544 35kb pdf.
Asphalt roofing shingles simply rely on the force of.
3 bundles 1 bundle of 20 and 2 bundles of 22 when applied according to instructions will cover 98 4 square feet 9 14 square meters.
Start by laying asphalt felt or other underlayment over the roof.
Most metal shingles will be attached to the roof using metal shingle.
Panel installation should begin at the gable end of the roof opposite the prevailing rain bearing wind this will provide added assurance against wind driven rain being forced under the laps.
It generally takes three bundles of shingles to cover 100 square feet.
Measure the length of a shingle as it lies across the roof.
Measure one panel width in from the roof edge.
Installation instructions instrucciones de instalación instructions d installation 1.
Remove old shingles and.
Installation instructions instrucciones de instalación general instructions coverage.
Roof decks and existing surfacing material must be dry prior to application of shingles.
Before you can begin to update your roof you will have to get an accurate measurement and order your materials.
Place the leading edge of the first panel along this line.
Using your staple gun secure the felt to the roof.
How to install asphalt shingles 1.
Lay the starter row of metal shingles at the drip edge and affix to the roof with metal roofing nails.
Continuing up the roof.
Beginning again with a full shingle repeat the five course pattern up the left rake figure 12 8 b.
Fill in courses across the roof in a stepped diagonal fashion using.
Understand the physics of how a sloped shingle roof works.
Measure the length width and rise of one section your roof.
This will help determine how the shingles will lay on the.
Install new flashing metal.
Step one in any roofing project is always safety first.
First measure the length and width of one section of the roof then measure the distance the roof rises from the lowest point to the highest point.
Preparing the roof 1.
Working at heights on a roof presents fall hazard risks and.
At this point chalk a line from ridge to eave.
If you live in an area with inclement weather you should consider using a special ice and water protector.
Use minimum 3 8 10 mm plywood or osb decking as recommended by apa the.
Gaf shingles must be installed on slopes of 2 12 or greater.